Ivory SWPPP


List of Contractor Do’s & Don'ts


DO:

  • DO go to the Site Storm Water Compliance Representative with any questions regarding storm water pollution prevention or this list.
  • DO place all trash and debris in the receptacles provided
  • DO use designated washout areas for cleaning equipment (e.g., concrete trucks, except those with self-contained washouts, must use the designated concrete washout area).
  • DO report any spills of petroleum or other chemicals to the Site Storm Water Compliance Representative.
  • DO immediately comply with any instructions given by the Site Storm Water Compliance Representative or other Ivory personnel.


DON’T:

  • DON’T allow any solvents, chemicals, or rinse liquids to drain into a street or storm drain, a creek, waterway, or other water body.
  • DON’T disable, damage, or interfere with any silt fence or similar erosion control device. (For example, DON'T run over a silt fence or straw wattle or forget to replace any silt fence or straw wattle you temporarily relocate)
  • DON’T disable, damage, or interfere with any inlet controls. (For Example, DON’T remove inlet controls (unless an action is needed to prevent flooding) or place dirt or debris in or adjacent to inlet controls.)
  • DON’T disable, damage, or interfere with any storm water pollution prevention controls at construction entrances. (For example, DON’T evade stone construction entrances.)
  • DON’T disable, damage, drive over, or interfere with any geotextile, matting or mulch
  • DON’T disable, damage, or interfere with any other storm water pollution prevention controls


Remember: The failure to comply with storm water requirements at this site is a breach of your contractual obligations and can result in economic sanctions or termination.